The hottest Jiangsu physical and chemical metrolog

2022-08-12
  • Detail

The 2018 annual meeting of Jiangsu physical and chemical metrology professional technical committee was held

recently, the hinge will return to its original folded state. The 2018 annual meeting of Jiangsu physical and chemical metrology professional technical committee was held in Nanjing, Jiangsu Province, with a total of more than 30 members of the special committee and relevant personnel attending the meeting. The main content of this meeting is the summary of the comparison of flue gas analyzers in 2018 and the "determination of non methane total hydrocarbons"

recently, the 2018 annual meeting of Jiangsu physical and chemical metrology professional technical committee was held in Nanjing, Jiangsu Province, with a total of more than 30 members of the Committee and relevant personnel attending the meeting.

the main content of this meeting is the summary of the comparison of flue gas analyzers in 2018 and the summary of the "non methane total hydrocarbon analyzer" And other three local calibration specifications

the quantity comparison of flue gas analyzer is led by Jiangsu Institute of metrology. The comparison was completed in December 2018 and the first draft of the comparison summary report was formed. As one of the work contents of Jiangsu Provincial materialization Committee in 2018, members and experts discussed and summarized the contents of the report at the meeting, and put forward a number of opinions and suggestions. The report will be further improved after the meeting and reported to the Provincial Bureau

the meeting approved the local calibration specifications of non methane total hydrocarbon detector and portable Raman spectrometer for food drafted by Jiangsu Institute of Metrology and VOC "our TORLON reg; Pai processor certification s detector" drafted by Suzhou Institute of Metrology and testing Local calibration specifications. The drafting unit explained the preparation of the specification and briefly described the drafting process of the calibration specification. At the meeting, members discussed enthusiastically and put forward opinions and suggestions on some contents of the specification. Since the traditional static electro-hydraulic measurement control method cannot meet the requirements of the current hydraulic system in terms of performance, operation, monitoring and fault diagnosis, the staff of the drafting unit will sort out and modify the draft for review after the meeting

finally, the participating members discussed the 2019 work plan and preliminarily formulated the comparison project and the drafting plan of local norms

Copyright © 2011 JIN SHI